[Dr_C2]

I see the issue was raised on slotracer.online on 7th January and then resolved with community input by 9th January. That’s fast support by any standard.

So is there anything to add nine months later?

I have one observation. Zippideedooda reported the lap detection problem only occurred for one lane. So why not both lanes - all things being equal?

My answer is:

1/ if there are any marginal differences then one lane may be affected first i.e. what prima facie appears equal may not be.

2/ for example the manufacturing of the phototransistors leads to variations in sensitivity. This is addressed by grading the phototransistors by sensitivity at the factory - but even then, some variation may still exist within graded batches.

3/ also for example, if the lap sensors are somewhere close to a curved track piece, can we be sure that the same vehicle travelling in either lane will be travelling at the same speed as it crosses the sensors? Probably not since vehicles in the ‘outer’ lane are likely to be travelling faster.

The point here is that tiny differences are sometimes overlooked and this can make trouble shooting more challenging.

c