[Dr_C2]

It’s getting exciting (well for me anyway).

The above mentioned new PCBs arrive tomorrow. First up will be to double check that all component positions are correct and that all track connections are correct.

All being well the next step will be assembly of the sensored brushless driver modules. Remember these sit between the digital decoder and the brushless motor.

There are eight assembly options … these consist of three sets of ‘ binary’ options - giving the total of eight combinations:

1/ cw or ccw rotation
2/ wiring as per either variant of the two motor types I am using (both were shown in earlier photos)
3/ then, there are two key versions - one for bespoke brushless decoders and one with an additional interface IC to connect with standard SSD, D132, SCX-A or O2 decoders.

The arrival of these boards is going to occupy a lot of my ‘hobby-time’ over the next few weeks for sure :)

Let’s see if we can nudge forward some useful progress with SENSORED brushless motors for digital slot-cars.

c