[Dr_C2]

While I wait for the above PCBs to be delivered, I’ve been preparing the final format of the piggy-back sensored brushless motor driver MODULE. I won’t commit this to manufacture until the above PCBs have been tested - just in case anything needs to be tweaked ;)

The later module measures approximately 15mm x 20mm and so should fit perfectly piggy-backed over the brushless motors which I have chosen which have a diameter of 15mm and a length of 25mm.

Next I will be looking at physical fit of the sensored brushless motors and matching modules into the following three NSR motor pods/cars:

1/ In-line pod for NSR F1 86/89.
2/ In-line pod for NSR F1 22
3/ AW pod for NSR Z4 and AMG etc.

Again, thanks for your interest - and without doubt what I am attempting will become far clearer when I share some photographs :)

c