[Dr_C2]

As I am now designing around the four wire interface I used for the 2023 demo of a 2-part high powered brushed motor solution, but this time for a brushless DC motor solution… this interface needs a name… so let’s call it a 4 wire motor control interface i.e. ‘4 wire MCI’.

Not to be confused with the I2C interface which also uses 4 wires and is something different.

The key benefit of using the above interface is that all necessary hardware components already exist - either from the 2023 demo or in the case of the motor driver board, as an ‘off-the-shelf’ part :)

Objective: ‘non-cogging’ brushless motors for digital slotcars.

c