pioneer legends - Printable Version

+- SlotRacer Forum (https://slotracer.online/community)
+-- Forum: Slot Cars (https://slotracer.online/community/forumdisplay.php?fid=3)
+--- Forum: 1:32 Scale (https://slotracer.online/community/forumdisplay.php?fid=4)
+--- Thread: pioneer legends (/showthread.php?tid=3550)

---

RE: pioneer legends - OXO cube - 24th-Feb-23

E-type Circlips
just an fyi 
Kev

---

RE: pioneer legends - fireman - 26th-Feb-23

hello thanks for all the replies.
I do mean the guide.
it is loose.
going to try using son circlips

---

RE: pioneer legends - KensRedZed - 26th-Feb-23

A straight flat washer will also work. It has to be a fraction smaller than the guide hole, and tight enough that it can't fall off.

Install it so the sharp part of the washer is facing up. The sharp edge will help keep it on.

Glad you got it sorted.

---

RE: pioneer legends - Kevan - 27th-Feb-23

A short length of silicone rubber tubing pushed down onto a washer will work well and take slop out of the setup.

---